Data Matrix Length Control - Datalogic Gryphon 2D Series Product Reference Manual

Symbology Selection

Data Matrix Length Control

This feature specifies either variable length decoding or fixed length decoding
for this symbology.
Variable Length:
may be set.
Fixed Length:
DEFAULT
Data Matrix Length Control = Fixed Length
Data Matrix
Specifies one of the bar code lengths for
225. Length 1 is the minimum label length if in
first fixed length if in Fixed Length Mode. Characters can be set from 0001 to
3,116 characters in increments of 0001 (pad with zeroes).
See page 302
Select Data Matrix Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
For variable length decoding, a minimum and maximum length
For fixed length decoding, two different lengths may be set.
Set Length 1
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
Enter/Exit Programming Mode
Data Matrix Length Control = Variable Length
Data Matrix Length Control on page
Variable Length
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
desired character(s). End by scanning the ENTER/EXIT
bar code again.
CANCEL
Mode, or the
representing your
225