Micro Pdf417 Length Control; Variable Length Mode; Appendix D, Keypad Representing Your - Datalogic Gryphon 2D Series Product Reference Manual

Enter/Exit Programming Mode

Micro PDF417 Length Control

This feature specifies either variable length decoding or fixed length decoding
for this symbology.
Variable Length:
may be set.
Fixed Length:
DEFAULT
Micro PDF417 Length Control = Fixed Length
Micro PDF417 Set Length 1
Specifies one of the bar code lengths for
234. Length 1 is the minimum label length if in
first fixed length if in Fixed Length Mode. Length includes the bar code's data
characters only. Characters can be set from 0001 to 0366 characters (pad with
zeroes) in increments of 01. Any value greater than 0366 will be considered to
be 0366.
See page 302
Select Micro PDF417 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
234
For variable length decoding, a minimum and maximum length
For fixed length decoding, two different lengths may be set.
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
Micro PDF417 Length Control = Variable Length
Micro PDF417 Length Control on page
Variable Length
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
desired character(s). End by scanning the ENTER/EXIT
bar code again.
CANCEL
Gryphon™ I GD/GBT/GM4500
Micro PDF417
Mode, or the
representing your