Password Change; Language In The Display; Language Change - AUMA ACVExC 01.2 Series Operation And Setting Manual

Actuator controls
ACV 01.2/ACVExC 01.2
3.4.2.

Password change

Select main menu
Change passwords
3.5.

Language in the display

3.5.1.

Language change

Select main menu
Only the passwords of same or lower user level may be changed.
Example: The user is signed in as Specialist (4). This authorises him or her to modify
the passwords between user levels (1) to (4).
Device configuration M0053
Service functions M0222
Change passwords M0229
Menu point Service functions M0222 is only visible if user level has been set to
Specialist (4) or higher.
1. Set selector switch to position 0 (OFF).
2. Press push button C Setup and hold it down for approx. 3 seconds.
Display goes to main menu and indicates: ▶ Display...
3. Select parameter Change passwords either:
click via the menu
via direct display: press
- Display indicates: ▶ Change passwords
- The user level is indicated in the top row (1 – 6), e.g.:
- For user level 1 (view only), passwords cannot be changed. To change pass-
words, you must change to a higher user level. For this, enter a password via
a parameter.
4. For a user level between 2 and 6: Press push button
The display indicates the highest user level, e.g.: For user 4
5.
Select user level via push buttons
Display indicates: ▶ Change passwords Password 0***
6. Enter current password (→ enter password).
Display indicates: ▶ Change passwords Password (new) 0***
7. Enter new password (→ enter password).
Display indicates: ▶ Change passwords For user 4 (example)
8. Select next user level via push buttons
via Esc.
The AUMATIC actuator controls display is multilingual.
Display... M0009
Language M0049
1. Set selector switch to position 0 (OFF).
to parameter, or
and enter ID M0229
Up ▲ Down ▼ and confirm with
Up ▲ Down ▼ or cancel the process
Operation
Ok.
Ok.
17