AUMA ACVExC 01.2 Series Operation And Setting Manual page 40

Basic settings for commissioning
CLOSED or OPEN
User login
Set end position
CLOSED CMD0009
Set end position OPEN
CMD0010
Information
40
4. Use Up ▲ Down ▼ to select:
▶ Set end pos.CLOSED? M0084
▶ Set end pos. OPEN? M0085
The black triangle ▶ indicates the current selection.
5. Ok.
Press
The display indicates either:
- Set end pos.CLOSED? CMD0009 → continue with step 9
- Set end pos. OPEN? CMD0010 → continue with step 14
- Specialist (4) → continue with step 6
6. Up ▲ Down ▼ to select user:
Use
Information: Required user level: Specialist (4) or higher
The symbols have the following meaning:
- black triangle: ▶ = current setting
- white triangle: ▷ = selection (not saved yet)
7. Press Ok to confirm to selected user.
Display indicates: Password 0***
8. Enter password (→ enter password).
The display indicates either:
- Set end pos.CLOSED? CMD0009 → continue with step 9
- Set end pos. OPEN? CMD0010 → continue with step 14
9. Set again end position CLOSED:
10. Press Yes to accept new end position setting.
Display indicates: End pos. CLOSED set!
The left LED is illuminated (standard version) and thus indicates that the end
position CLOSED setting is complete.
11. Make selection:
Edit → back to step 9: Set end position CLOSED "once again"
Esc → back to step 4; either set end position OPEN or exit the menu.
12. Re-set end position OPEN:
13. Press Yes to accept new end position setting.
Display indicates: End pos. OPEN set!
The right LED is illuminated (standard version) and thus indicates that the end
position OPEN setting is complete.
14. Make selection:
Edit → back to step 9: Set end position OPEN "once again"
Esc → back to step 4; either set end position CLOSED or exit the menu.
If an end position cannot be set: Check the type of control unit in actuator.
Actuator controls
ACV 01.2/ACVExC 01.2