Table of Contents
Advertisement
Symptom:
P0443-EVAP PURGE SOLENOID CIRCUIT
When Monitored and Set Condition:
P0443-EVAP PURGE SOLENOID CIRCUIT
When Monitored: The ignition on or engine running. Battery voltage greater than 10
volts.
Set Condition: The PCM will set a trouble code if the actual state of the solenoid does not
match the intended state.
GOOD TRIP EQUAL TO ZERO
EVAP PURGE SOLENOID OPERATION
(K52) EVAP PURGE SOL CONTROL CIRCUIT OPEN
(K52) EVAP PURGE SOLENOID CONTROL CIRCUIT SHORTED TO GROUND
(K108) EVAP PURGE SOL RETURN CIRCUIT OPEN
(K108) EVAP PURGE SOL RETURN CIRCUIT SHORTED TO GROUND
POWERTRAIN CONTROL MODULE
TEST
1
Ignition on, engine not running.
With the DRBIII , read DTCs and record the related Freeze Frame data.
Is the Good Trip Counter displayed and equal to zero?
Yes → Go To 2
→ Refer to the INTERMITTENT CONDITION symptom in the
No
2
Turn the ignition off.
Disconnect the EVAP Purge Solenoid harness connector.
Ignition on, engine not running.
Using a 12-volt test light, jumper across the EVAP Purge Solenoid harness connector.
With the DRBIII , actuate the EVAP Purge Solenoid.
Does the test light flash on and off?
Yes → Replace the EVAP Purge Solenoid.
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
173
APPLICABILITY
All
All
Advertisement
Table of Contents
