Program List And Explanations; Messages; Diagnostics - Swan Analytical Instruments AMI Codes-II TC Operator's Manual

AMI Codes-II TC

Program List and Explanations

9.

1 Messages

1.1 Pending Errors
1.1.5
1.2 Maintenance List
1.2.5
1.2 Message List
1.3.1

2 Diagnostics

2.1 Identification
2.1.3
2.1.4
2.1.5
2.2 Sensors
2.2.1
2.2.1.4
80
Program List and Explanations
Provides the list of active errors with their status (active,
acknowledged). If an active error is acknowledged, the alarm relay
is active again. Cleared errors are moved to the Message list.
Demands necessary maintenance, e.g. preparing new reagents.
Shows the error history: Error code, date / time of issue and status
(active, acknowledged, cleared). 65 errors are memorized. Then
the oldest error is cleared to save the newest error (circular buffer).
In diagnostics mode, the values can only be viewed, not modified.
Designation: View the Designation of instrument.
Version: Firmware of instrument (e.g. V6.20-05/18)
Peripherals: PeriClip 1: Firmware of peristaltic pump (e.g. 1.06)
Factory Test: Test date of the Instrument, Motherboard and
Frontend. QC factory test.
Operating Time: Years/Days/Hours/Minutes/Seconds
Photometer:
Absorbance: Process value, depends on sample.
Raw value: Shows the actual photometer signal in Hz.
Cal. History: Shows the diagnostic values of the last calibrations.
Number: Counter for the calibrations
Date, Time: Date and time assigned to a number.
Slope: Slope photometer: 0.8–1.2
A-96.250.631 / 280219