Lift Sensor Removal/Installation; Area Sensor; Removal/Installation - Honda HRM300 Manual

dummyhead dummyhead
LIFT SENSOR

REMOVAL/INSTALLATION

Do the preventive measure of static electricity before
removal/installation. main ECU, display, battery and
sensor etc. may be damaged because of static
electricity (page 3-2).
Turn OFF the main switch.
Remove the upper frame (page 10-2).
Disconnect the 3P connector [1].
Remove the two tapping screws [2] and lift sensor [3].
• Place the lift sensor quietly with the stable position
on an insulator without trash, dust, and moisture etc.
Installation is the reverse order of removal.
• Direct the connector of the lift sensor to inner side
and install it.
TORQUE:
LIFT SENSOR SCREW:

AREA SENSOR

REMOVAL/INSTALLATION
Do the preventive measure of static electricity before
removal/installation. main ECU, display, battery and
sensor etc. may be damaged because of static
electricity (page 3-2).
FRONT RH/LH AREA SENSOR
Turn OFF the main switch.
Remove the following:
– Top cover (page 7-2)
– Main cover (page 7-5)
Disconnect the terminals [1].
Remove the two bolts [2], washers [3], collars [4] and
special nuts [5].
Remove the two special bolts [6] and nuts [7].
Remove the front area sensor cover [8] and frame seal
D [9].
Disconnect the 2P connector [10].
Remove the two tapping screws [11] and area sensor
[12].
• Place the area sensor quietly with the stable position
on an insulator without trash, dust, and moisture etc.
Installation is the reverse order of removal.
• Direct the connector of the area sensor to backside
and install it.
• Replace the frame seal D.
TORQUE:
AREA SENSOR SCREW:
LH lift sensor shown:
0.4 N·m
(0.04 kgf·m, 0.3 lbf·ft)
[8]
0.4 N·m
(0.04 kgf·m, 0.3 lbf·ft)
OTHER ELECTRICAL
[1]
[9]
[1]
[4]
[5]
[2]
[3]
[2]
[3]
[6]
[11]
[12]
[10]
[7]
10-5