Honda HRM300 Manual page 299

dummyhead dummyhead
COVER
Remove the stop switch 4P connector [1] from
connector holder of the top cover [2].
Remove the wire harness from groove of the top cover.
Remove the screw [1], washer [2] and self-lock nut [3],
and then rotate the stop switch [4].
Remove the stop switch by releasing the projections [5]
of the stop switch from the groove of the top cover.
Assembly is reverse order of disassembly.
• Insert the screws from inner side.
• Note the direction of the manual stop button spring.
• Be careful not to break the stop switches when
installing the stop switch bracket.
• Check whether the manual stop button operates
correctly after installation.
• Be careful not to bend the stop switch bracket.
TORQUE:
FRONT COVER SCREW:
STOP SWITCH SCREW/
SELF-LOCK NUT:
After installation, check the clearance between stop
switch bracket [1] and top cover [2].
The clearance should be 5.2 mm.
If the clearance is not 5.2 mm, adjust it by bending the
stop switch bracket carefully.
Do not bend the stop switch bracket excessively.
7-4
1.2 N·m
(0.12 kgf·m, 0.9 lbf·ft)
0.4 N·m
(0.04 kgf·m, 0.3 lbf·ft)
[1]
[3]
[4]
[2] [1]
[2]
[2]
[5]
[4]
5.2 mm
[1]