Station Disassembly/Assembly - Honda HRM300 Manual

dummyhead dummyhead
DOCKING STATION

STATION DISASSEMBLY/ASSEMBLY

DOCKING STATION
• Do the preventive measure of static electricity before removal/installation. The station ECU may be
damaged because of static electricity (page 3-2).
• If the station ECU is dropped, do not use it because it may have been damaged.
• The station ECU may be damaged, if trash and dust go into the inside. Perform removal/installation indoors.
STATION COVER
STATION INDICATOR LENS/
INDICATOR LENS GROMMET
Radio signal cord (page 6-23)
STATION SEAL
Visually inspect the station seal
for dust or other damage before
installation. If necessary, wipe it
with a clean lint-free cloth or
replace it. Avoid grease on any
electrical parts.
STATION HARNESS
COVER
CONNECTOR BASE
STATION HARNESS
REMOVAL:
Pull out the terminal from connector base after
pushing the projection of terminal by a suitable tool.
INSTALLATION:
·If the terminal is pulled out from the connector base,
replace the station harness.
·Route the wire harness in the proper positions
securely (page 4-5).
11-2
BOLT (6 x 32 mm) (2)
WASHER (2)
NUT (6 mm) (2)
TAPPING SCREW (5 mm) (4)
0.6 N·m (0.06 kgf·m, 0.4 lbf·ft)
CHARGE PLUG UPPER COVER
INSTALLATION:
Insert the projection of the upper cover
into the hole of the lower cover, and
then slide the upper cover and hook the
projection.
projection
CHARGE PLUG (2)
Check the charge plug
for damage, bent and
rust before installation.
Replace it if necessary.
CHARGE PLUG LOWER COVER
COLLAR (2)
TAPPING SCREW (5 mm) (2)
2.0 N·m (0.20 kgf·m, 1.5 lbf·ft)
STATION ECU
·Hold the side face when you
pull it up/down.
·Place the station ECU quietly
with the stable position on an
insulator without trash, dust,
STATION
and moisture etc.