Basic Installation Pattern Of The Boundary Wire; Short Cut Wire: One Line - Honda HRM300 Manual

dummyhead dummyhead

BASIC INSTALLATION PATTERN OF THE BOUNDARY WIRE

Make a loop shape by the boundary wire starting from the docking station.
Maximum length between the boundary wire and the lawnmower is 30m.
If the lawnmower is more than 30m away from the boundary wire, the lawnmower cannot detect the signal (pulse current).
Total length of the boundary wire should be less than 500m.
Do not make passages for lawnmower less than 1m in width.
OBSTRUCTION
DOCKING STATION
BOUNDARY WIRE
If the distance between the
wires is 20cm, in order to let the
mower cross the shortcut wire
while mowing, wire overlap
setting should be set to a value
over 35cm and incident angle
to the wire is 60 degrees or
more.
No other wire than those shown below in the rectangle is authorized.
A = 250cm
B = 300cm
The short cut wire ensures an expedited return to the docking station under certain circumstances.

SHORT CUT WIRE: ONE LINE

Distance from the center screw to
the end of the short cut wire should
be 80 - 85cm
The sensitivity level setting should be high or middle (page 3-9).
30 - 50cm
30cm
HOME
20cm or less
Divide the mowing zone: More than wire overlap set up value (page 3-11).
B
A
30cm
1. In order to let the mower cross the shortcut wire while mowing, wire
overlap setting should be set to a value over 35cm (page 3-11).
2. When the depth of the wire is over 5cm, wire distance should be 16 -
20cm.
25 - 30cm
A
25 - 30cm
90 degrees
18 - 20cm
INSTALLATION
SHORT CUT WIRE
5mm or less
(If the distance between the
wires is more than 10 mm, the
lawnmower will detect the
boundary wire and slow down or
rotate)
Do not intersect.
Do not setup less
than 90 degrees.
3-7