Blade Removal And Installation - Honda HRJ196 Manual

42VL96000.book 49 ページ ２０１２年１０月５日 金曜日 午前１０時７分

BLADE REMOVAL AND INSTALLATION

If you remove the blade, use a torque wrench to reinstall. Wear heavy
gloves to protect your hands. To avoid weakening the blade, or causing
imbalance or poor cutting, the blade should be sharpened by trained
staff at your servicing dealer. If replacing the blade, use a Honda
genuine replacement blade or equivalent.
Removal
1.Turn the fuel valve to the OFF
position.
2.Disconnect the spark plug cap, then
tilt the mower to the right side, so
the carburetor side is up.
3.Hold the blade disc firmly, and
remove the blade disc holder bolt.
Set a flat blade screwdriver at the
engine's bolt to prevent the blade
disc from turning when removing
the blade disc holder bolt.
BLADE DISC HOLDER BOLT
BLADE DISC
BLADE DISC'S
HOLE
ENGINE'S
BOLT
FLAT BLADE
SCREWDRIVER
49