Honda HRM300 Manual page 130

dummyhead dummyhead
"Excessive Tilt" MESSAGE
Put HRM300/500 on the level surface (15 ° or
less ) and input the PIN code (page 3-16).
Abnormal
Can input by the ten digits keypad.
Cannot input
Can
input
Keypad trouble of the display
ECU.
Replace the display (page 10-3).
Forget the PIN code.
Connect the Dr.H and convey or re-set the PIN
code (see the Dr.H manual).
Normal
Recheck the warning message in the display.
Abnormal
Horizontal or vertical direction is shown 0 ° in
the tilt sensor test from the test mode (page 3-
38).
Shown 0 °
Calibrate the tilt sensor (page 3-43).
Warning does
not reset
Main ECU trouble.
Replace the main ECU (page 10-7).
TROUBLESHOOTING
Normal
Temporary failure.
Not shown 0 °
Calibrate the tilt sensor
(page 3-43).
Shown 0 °
Temporary failure.
Not shown 0 °
Main ECU trouble.
Replace the main ECU
(page 10-7).
Warning reset
Temporary failure.
6-25