Honda HRM300 Manual page 205

dummyhead dummyhead
INSTALLATION
2 Quick Setup (Simple setting mode)
Timer
2-1
Mon-Tue-Wed-Thu-Fri-Sat-Sun
Start Time & End Time 1
Start Time & End Time 2
• "Passage width (out)" setting cannot be adjusted in Quick setup menu.
• In Quick setup mode, "Passage width (out)" value is equal to "Passage return width" value and this value can be adjusted in "System
setup" menu (page 3-55).
• If the shortcut wire was installed, "Distance" value in the "Wire Exit Location setting" should be set up to the distance before the
lawnmower reaches the shortcut wire (See below).
1m or more (The lawnmower can not go through the passage less than 1m in width)
5mm or less
(If the wire width is more than 10
mm, the lawnmower will detect
the boundary wire and slow
down or rotate)
3-20
Menu
1.Auto Mode
2.Quick Setup
3.Custom Setup
4.Test
5.History
6.System Setup
Quick Setup
2
2-2-1 2-2-2
Zone Proportion (%)
Wire Exit Location
Distance
CW ACW
ZONE2
Custom setup should be preferred to
Quick setup in following situations.
-More than two zones need to be setup.
-Working time has to be precisely
adjusted (e.g. to synchronize with
automatic watering system, etc.)
-You do not want the mower to start
mowing from its docking station.
Zone
2-2
2-2-3
Mowing Pattern
Random Directional
ZONE1
SHORTCUT WIRE
Summary Reset
2-3
2-4
Timer Summary
Zone Summary
2-2-4
Area
Mixed Wire Overlap
OK
Wire exit location
should be set
before reaching
the shortcut wire.
NG