Upper Frame Removal/Installation - Honda HRM300 Manual

dummyhead dummyhead
OTHER ELECTRICAL

UPPER FRAME REMOVAL/INSTALLATION

OTHER ELECTRICAL
Disconnect the battery 4P connector before disconnecting/connecting the connector from/to main ECU.
Turn OFF the main switch.
Remove the following:
– Top cover (page 7-2)
– Main cover (page 7-5)
Remove the special bolts, nuts and special nuts.
Lift the upper frame slightly and disconnect the battery 4P connector.
Disconnect the main ECU 30P connector and remove the upper frame.
Remove the frame seal A and B.
Installation is the reverse order of removal.
• Replace and apply grease to the frame seal A and B.
SPECIAL NUT
(6 mm) (2)
10-2
SPECIAL BOLT (6 mm) (12)
INSTALLATION:
Tighten the special bolts in the numbered
sequence as shown in 2 or 3 steps.
6
10
UPPER FRAME
MAIN ECU 30P CONNECTOR
FRAME SEAL A
FRAME SEAL B
NUT (6 mm) (10)
8
12
4
2
3
9
1
5
BATTERY 4P CONNECTOR
11
7