Before Troublehsooting; Docking System Troubleshooting - Honda HRM300 Manual

dummyhead dummyhead
TROUBLESHOOTING
BEFORE TROUBLESHOOTING
• Use a known-good battery for troubleshooting.
• Check that the connectors are connected securely.
• Read the circuit tester's operation instructions carefully, and observe the instructions during inspection.

DOCKING SYSTEM TROUBLESHOOTING

The error message is displayed (page 3-15).
Not displayed
HRM300/500 can dock to the station.
Cannot dock
Check if foreign material blocks the wheel(s).
Abnormal
Normal
Remove the foreign substance of
the wheel(s).
Check the setting of HRM300/500 (page 3-53).
Abnormal
Normal
Set the setting again (page 3-9).
Check the boundary wire installation (page 3-12).
Abnormal
Normal
Install the boundary wire correctly
(page 3-12).
Check the charge plug and socket for damage,
bent and rust.
Abnormal
Normal
Charge plug and/or socket
trouble.
Replace or repair the charge plug
and/or socket (page 10-6, 11-2).
Between the main ECU 2P connector
and charge socket terminals (
) of sub wire harness trouble.
Replace or repair the sub wire harness.
6-4
Displayed
Can dock
and
Check the error message and perform the
troubleshooting for fault/warning message
(page 6-8, 6-9, 6-10).
Check the charge current on the display with
docking to the station.
(Normal charging current is 1A or more.)
Abnormal
Normal
Battery trouble.
Replace the battery (page 10-7).
Check the transformer (page 11-3).
Abnormal
Normal
Transformer trouble.
Replace the transformer.
Check the power supply.
Abnormal
Normal
Repair the power supply.
(Contact an electric power
company if necessary.)
Main ECU trouble.
Replace the main ECU (page 10-7).