Mount Shaft Removal/Installation - Honda HRM300 Manual

dummyhead dummyhead
OTHER ELECTRICAL

MOUNT SHAFT REMOVAL/INSTALLATION

REMOVAL
Remove the following:
– Top cover (page 7-2)
– Main cover (page 7-5)
Front mount shaft shown:
MOUNT WASHER
SPRING PLATE
MOUNT SPRING (3)
SPECIAL NUT (3)
INSTALLATION
Install the mount springs [1] to spring plate [2] and
spring washer [3].
Install the spring plate in the position as shown.
• Set the projection [4] of the spring plate between the
ribs [5] of the upper frame.
Install the mount washer [1] by aligning the projections
[2] of the rib with cutouts [3] as shown.
Check whether mount shaft is with the magnet, and
install the mount shaft.
• Front and right mount shaft are with magnet.
• Left mount shaft is without
magnet.
Install the special nuts and mount plate, and tighten the
special bolts.
• Direct the small projections of the mount plate to
downside and install it.
10-4
MOUNT PLATE
Front mount shaft:
with magnet
SPRING WASHER
Front mount shaft shown:
[1]
[3] [3]
Front mount shaft shown:
[1]
SPECIAL BOLT (6 mm) (3)
MOUNT SHAFT
Right mount shaft:
with magnet
Left mount shaft:
without magnet
[2]
[4]
[5]
[3]
[2]