Installation - Honda HRM3000 Owner's Manual

Installation

Installation
We recommend that an authorised Honda dealer performs the installation of your Robotic Lawnmower.
Checking conditions for installation
Check with the dealer that performed the installation if the docking station and boundary wire are installed
according to the conditions below. Also periodically confirm that these conditions are still met.
If any of these conditions are not met, consult your dealer.
It is recommended that the mains power supply is professionally installed in line with local laws and regulations.
Conditions for installing the docking station
5° (8.7%)
5° (8.7%)
Docking direction
Pattern 1
Pattern 3
12
Image
5° (8.7%)
5° (8.7%)
20 cm or more
1 m or more
Pattern 2
Pattern 4
Condition
• The docking station must be installed on a flat
surface with an inclination of no more than 5°
(8.7%).
• The docking station must not be curved.
• The screws must be firmly tightened.
• Before installing the docking station, check the
ground condition which may vary seasonally. It
may be necessary to maintain the ground with
the season.
• If installing the docking station directly on
the lawn, cut the grass on which the docking
station will be located as short as possible.
• Because of a wrong installation of the docking
station, the lawnmower may not be charged.
Install the docking station in a place where there
are no obstacles in the area indicated with the
slanted line.
Docking direction
There are four patterns for installing the docking
station.