General Description; Preparation And Checks Before Use; Unpacking; Assembly Of The Handle - Honda HRX537C Owner's Manual

Pedestrian-controlled lawnmower
Hide thumbs Also See for HRX537C:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

GENERAL DESCRIPTION

HZEA type
[13]
[14]
[12]
D [STICKER]
[11]
[10]
VKEA type
[25]
[15]
C [STICKER]
[23]
[24]
[22]
1
Shift lever
2
Throttle lever
3
Handlebar
4
Discharge guard
5
Fuel tank cap
6
Cutting-means enclosure
7
Muffler
8
Electric starter (HZEA only)
9
Oil filler cap
10 Clip Director knob
Battery charger connector
11
HZEA only)
12 Recoil starter
13 Key switch (HZEA only)
14 Battery box (HZEA only)
4 EN
HYEA type
[15]
[1]
[2]
[3]
[4]
A [STICKER]
[5]
[8]
[9]
VYEA type
[25]
[4]
[19]
[20]
[26]
[21]
B [STICKER]
Cutting-means control (Starts
15
and stops the cutting means)
16 Roto-Stop button
Drive clutch control
17
(Transmission control which
drives the rear wheels)
18 Grass catcher
19 Handlebar adjust knob (2)
20 Fuel valve
21 Air cleaner
22 Carburetor
23 Spark plug cap
Cutting height adjustment
24
lever (4)
25 Select Drive control
26 Engine serial number
PREPARATION AND CHECKS
BEFORE USE
[16]

UNPACKING

Remove all the cardboard from around the handlebar.

ASSEMBLY OF THE HANDLE

[17]
1. Turn the handlebar adjust knobs [1] 90 degrees into the unlock
position [2].
2. Move the handlebar into the mowing position so that the locating pins
align with either the upper, middle, or lower holes on the handlebar
mounting brackets.
[6]
3. Turn the adjust knobs 90 degrees into the lock position [3] and the pins
will snap into the holes and lock into position.
[7]

CHECKING THE BATTERY (HZEA)

[2]
The lawnmower has an internal charging system. Under normal mowing
usage it is not necessary to charge or maintain the battery.
The mower is shipped with the ignition key in the parts bag. Install the key
in the key switch.

CHECKING THE REAR SHIELD

During normal use the rear shield [1] is subject to deterioration and wear.
Remove the grass catcher [2] and raise the discharge guard [3] to check
the rear shield for cracks or tears. If the rear shield is excessively worn, have
it replaced by your authorized Honda servicing dealer.
[3]
B3
SAFETY
[1] (2)
[2]
[3]
[2]
[1]

Advertisement

Table of Contents
loading

Table of Contents