General Description; Preparation And Checks Before Use; Unpacking; Assembly Of The Handle - Honda HRN536C Operator's Manual

GENERAL DESCRIPTION

VKEA Type
[1]
[11]
[2]
[18]
[12]
C (STICKER)
[6]
[4]
[5]
VYEA Type
[11]
C (STICKER)
[1]
[2]
[18]
[3]
[12]
[6]
[4]
[5]
Cutting-means control lever (Starts
1
and stops the cutting means)
2 Handlebar
3 Fuel tank cap
4 Cutting-means enclosure
5 Muffler
6 Oil filler cap
7 Clip Director knob
8 Cutting height adjustment lever (2)
9 Grass catcher
10 Recoil starter
4 EN
[10]
A (STICKER)
[16]
[3]
[14]
[15]
B (STICKER)
[8]
[17]
[20]
[10]
A (STICKER)
[16]
[14]
[15]
B (STICKER)
[8]
[17]
11 Smart Drive control
12 Handlebar adjust knob (2)
13 Fuel valve
14 Engine serial number
15 Air cleaner
16 Carburetor
17 Spark plug cap
18 Discharge guard
19 Throttle Lever (VYEA)
20 Roto-Stop Button (VYEA)
PREPARATION AND CHECKS
BEFORE USE

UNPACKING

Remove all the cardboard from around the handlebar.

ASSEMBLY OF THE HANDLE

Turn the handlebar adjust knobs into the unlocked position, and then
carefully raise the handlebar into the mowing position . The VKEA type
requires the cutting-means control lever to be pulled against the
[9]
handlebar.
[8]
[7]

[13]
Align the adjust knobs with one of the two holes on each handle stay.
Setting the adjust knobs in the lowest holes raises the handlebar to its
highest position.
Turn the handlebar adjust knobs 90 degrees into the locked position,
making sure both sides are positioned at the same height.
[19]
NOTICE
Do not allow the control cables to become caught, pinched, or kinked while
[9]
unfolding the handlebar. The cables or engine control system may be
damaged.
[8]
[7]

CHECKING THR REAR SHIELD

During normal use the rear shield is subject to deterioration and wear.
[13]
Remove the grass catcher and raise the discharge guard [1] to check the
rear shield [2] for cracks or tears. If the rear shield is excessively worn, have
it replaced by your authorized Honda servicing dealer.
B3
SAFETY

HANDLEBAR
ADJUST KNOBS
UNLOCKED
LOCKED
[1]
[2]