Connection To Stepper-Motor Controller With 5V Signal Level (X5); Connection To Stepper-Motor Controller With 24V Signal Level (X3) - Beckhoff AX2000 Assembly, Installation, Setup

Interfaces
4.9.1

Connection to stepper-motor controller with 5V signal level (X5)

This interface can be used to connect the servo amplifier to a stepper-motor controller with 5V
signal level. The connector X5 must be used.
Frequency limit: 1,5MHz
AGND and DGND (connector X3) must be joined together !
4.9.2

Connection to stepper-motor controller with 24V signal level (X3)

This interface can be used to connect the servo amplifier to a stepper-motor controller with 24V
signal level. The digital inputs DIGITAL-IN 1 and 2 at connector X3 must be used.
Frequency limit: 250 kHz
AGND and DGND (connector X3) must be joined together !
54
AX2000
AX2000
02/06
AX2000 Installation manual
BECKHOFF
- A.4.031.1/10,45