Wiring - Beckhoff AX2000 Assembly, Installation, Setup

BECKHOFF
3.4

Wiring

Only professional staff who are qualified in electrical engineering are allowed to
install the servo amplifier.
The installation procedure is described as an example. A different procedure may be sensible or
necessary, depending on the application of the equipment.
We provide further know-how through training courses (on request).
Warning !
Only install and wire up the equipment when it is not live, i.e. when neither the
mains power supply nor the 24 V auxiliary voltage nor the operating voltages of
any other connected equipment is switched on.
Take care that the cabinet is safely disconnected (with a lock-out, warning signs
etc.). The individual voltages will be switched on for the first time during setup.
The ground symbol
that you must take care to provide an electrically conductive connection with the
largest possible surface area between the unit indicated and the mounting plate in
the switchgear cabinet.
This connection is for the effective grounding of HF interference, and must not be
confused with the PE- symbol W (a protective measure to EN 60204).
Use the following connection diagrams:
Overview
Multi-axis systems, example
Mains power
Motor
Feedback:
Encoder Emulation:
RS232 / PC
CAN Interface
Restart lock option -AS-
Expansion cards:
AX2000 Installation manual
X
, which you will find in all the wiring diagrams, indicates
Resolver
Incr.Enc. or Sine Enc. with Hall
Encoder with EnDat/HIPERFACE
Incremental encoder (AqB)
Encoder without data channel
ROD (A quad B)
SSI
Master-Slave Interface
Pulse-Direction Interface
I/O-14/08
PROFIBUS
SERCOS
DeviceNet
EtherCat
SynqNet
-2CAN-
02/06
: page 30
: page 29
: page 38
: page 39
: page 40
: page 41
: page 42
: page 43
: page 44
: page 49
: page 50
: page 51
: page 53
: page 55
: page 56
: page 67
: page 73
: page 74
: page 76
: page 77
: page 80
: page 82
: page 84
Installation
29