Master-Slave Operation, Encoder Master Control; Connection To A Ax Master, 5V Signal Level (X5) - Beckhoff AX2000 Assembly, Installation, Setup

BECKHOFF
4.8

Master-slave operation, encoder master control

This interface can be used to link several AX2000 amplifiers together in master-slave
operation.
The parameters for the slave amplifiers are set up with the aid of the setup software.
The resolution (no. of pulses/turn) can be adjusted. The analog setpoint inputs are out of action.
AGND and DGND (connector X3) must be joined together !
Signal diagram (for encoders with RS422 or 24V output)
4.8.1

Connection to a AX master, 5V signal level (X5)

This interface can be used to link several AX amplifiers together in master-slave operation. Up to 16
slave amplifiers can be controlled by the master via the encoder output. The connector X5 must be
used.
Frequency limit: 1,5MHz, slew rate tv £ 0,1µs
AGND and DGND (connector X3) must be joined together !
AX2000 Installation manual
AX2000
02/06
Interfaces
- A.4.031.1/16,3/2
AX2000
51