Notes On Connection Techniques; Shielding Connection To The Front Panel - Beckhoff AX2000 Assembly, Installation, Setup

BECKHOFF
3.4.4

Notes on connection techniques

3.4.4.1

Shielding connection to the front panel

AX2000 Installation manual
02/06
- A.4.029.4/25
Installation
Remove the outer covering of the cable
and the shielding braid from the cores
for the required length. Secure the cores
with a cable tie.
Remove the outer covering of the cable
over a length of about 30mm, without
damaging the shielding braid.
Pull a cable tie through the slot in the
shielding rail (front panel) of the servo
amplifier.
Use the cable tie to clamp the shielding
braid of the cable firmly to the shielding
rail.
33