Connection To A Stepper Motor Controller With 5V Signal Level (X5); Connection To Stepper Motor Controller With 24V Signal Level (X3) - Beckhoff AX2040 Assembly, Installation, Setup

Beckhoff
4.10.1

Connection to a stepper motor controller with 5V signal level (X5)

This interface can be used to connect the servo amplifier to a stepper-motor controller with 5V
signal level. The connector X5 must be used.
Edge frequency: 1.5MHz
AGND and DGND (connector X3) must be joined together !
4.10.2

Connection to stepper motor controller with 24V signal level (X3)

This interface can be used to connect the servo amplifier to a stepper-motor controller with 24V
signal level. The digital inputs DIGITAL-IN 1 and 2 at connector X3 must be used.
Edge frequency: 250 kHz
AGND and DGND (connector X3) must be joined together !
AX2040/2070 Installation Manual
AX2040/2070
AX2040/2070
02/06
Interfaces
- A.4.031.1/10,4
61