Features - ST STM32MP157C-DK2 User Manual

1

Features

• Common features
– STM32MP157 Arm
– ST PMIC
– 4-Gbit DDR3L, 16 bits, 533 MHz
– 1-Gbps Ethernet (RGMII) compliant with IEEE-802.3ab
– USB OTG HS
– Audio codec
– 4 user LEDs
– 2 user and reset push-buttons, 1 wake-up button
– 5 V / 3 A USB Type-C
– Board connectors:
◦
◦
◦
◦
◦
◦
◦
◦
◦
– On-board ST-LINK/V2-1 debugger/programmer with USB re-enumeration capability: Virtual COM port
and debug port
– STM32CubeMP1
as STM32MP1Starter) software and examples
– Support of a wide choice of Integrated Development Environments (IDEs) including IAR
based IDEs
• Board-specific features
– 4" TFT 480×800 pixels with LED backlight, MIPI DSI
– Wi‑Fi
– Bluetooth
Note: Arm is a registered trademark of Arm Limited (or its subsidiaries) in the US and/or elsewhere.
UM2534 - Rev 1
®
-based dual Cortex
STPMIC1
™
power supply input (not provided)
Ethernet RJ45
4 × USB Host Type-A
™
USB Type-C DRP
MIPI DSI SM
®
HDMI
Stereo headset jack including analog microphone input
™
microSD card
GPIO expansion connector (Raspberry Pi
™
Arduino Uno V3 expansion connectors
and full mainline open-source Linux
®
802.11b/g/n
®
Low Energy 4.1
® ®
-A7 32 bits + Cortex -M4 32 bits MPU in TFBGA361 package
®
shields capability)
®
STM32 MPU OpenSTLinux Distribution (such
SM
interface, and capacitive touch panel
UM2534
Features
™ ®
, Keil , GCC-
page 2/47