4.
Click the [OK] button to add the module labels of the RJ51AW12AL.
5.
Set the items in "Basic setting" as follows.
[Navigation window] [Parameter] [Module Information] [RJ51AW12AL] [Module Parameter] [Basic setting]
6.
Write the set parameters into the CPU module, and reset the CPU module or power off and on the system.
[Online] [Write to PLC]
In this example, default values were used for parameters that are not shown above. For the parameters, refer
to the following.
Page 48 PARAMETER SETTINGS
3.2 Communication Example When the Slave Module is Added or Deleted
3 PROGRAMMING
67
3