Welch Allyn VSM 6000 series Directions For Use Manual page 71

Directions for use
Automatic intervals
You can configure the monitor to take automatic NIBP measurements at consistent intervals.
Note
Start automatic intervals
Follow these steps to configure the monitor to take NIBP measurements at consistent intervals.
1. Properly size the blood pressure cuff and position it around the patient's bare upper arm.
2. On the Home tab, touch
3. Select Automatic.
4. Use the numeric keypad to enter the length of time between NIBP measurements.
5. Touch Start intervals.
Note
Program intervals
You can configure the monitor to take automatic NIBP measurements at variable intervals. The
monitor comes with preset interval programs that can be edited to meet your needs. The numbers
below the program name indicate the length of time between each interval in the cycle.
An alarm does not turn off intervals. Subsequent automatic measurements continue
to occur as scheduled.
.
Intervals are not available in all profiles. See the Profiles section for
more information.
Patient monitoring 65