Welch Allyn VSM 6000 series Directions For Use Manual page 117

Directions for use
Minimum alarm volume
Nurse call threshold
Audio pause time
SpO2 alarm condition delay
4. Do one of the following:
•
•
Specify advanced display settings
1. Access the Advanced Settings.
a.
b.
c.
d.
The General tab appears.
2. Touch the Display tab.
3. Specify settings.
Setting
Display lock
Display power saver
Device power down
4. Do one of the following:
•
•
To continue in the Advanced Settings, touch another tab.
To exit the Advanced Settings and return to the Home tab, touch Exit.
Touch the Settings tab.
Touch the Advanced tab.
Enter the Advanced settings code.
Touch OK.
To continue in the Advanced Settings, touch another tab.
To exit the Advanced Settings and return to the Home tab, touch Exit.
Advanced settings 111
Select the minimum alarm volume available. If you
High Medium
select , then
available to the clinician.
These controls are on the Alarms tab (on the
General tab).
Select the minimum priority alarm that activates a
nurse call relay. If you select
alarms activate a nurse call relay.
Specify the amount of pause time that is added to
the 60-second pause time. When a clinician pauses
an audio alarm tone, the tone is paused for the
combined amount of time.
Specify the minimum amount of time that an SpO2
alarm condition must be active before audio and
visual signals occur.
SatSeconds is available with Nellcor SpO2 sensors.
If you select 0 seconds or 10 seconds, SatSeconds
is disabled, and it is removed from the SpO2 tab in
the Alarms tab.
Action/Description
Specify the required period of clinician inactivity
before the touchscreen locks.
Specify the required period of monitor inactivity
before the display turns off.
Clinician interactions, new vital sign
measurements, or alarm conditions automatically
turn on the display.
Specify the required period of monitor inactivity
before the monitor turns off.
Low
and are not
High
, only high-level