Welch Allyn VSM 6000 series Directions For Use Manual page 125

Directions for use
1. Access the Advanced Settings.
a.
b.
c.
d.
The General tab appears.
2. Touch the Network tab.
3. Touch the Radio tab.
4. Specify settings.
Setting
SSID
Radio band
Authentication type
Method
Enable radio
Enable radio network alarms
Configure radio
5. Do one of the following:
•
•
Specify server settings
1. Access the Advanced Settings.
a.
b.
c.
d.
Touch the Settings tab.
Touch the Advanced tab.
Enter the Advanced settings code.
Touch OK.
To continue in the Advanced Settings, touch another tab.
To exit the Advanced Settings and return to the Home tab, touch Exit.
Touch the Settings tab.
Touch the Advanced tab.
Enter the Advanced settings code.
Touch OK.
The General tab appears.
Advanced settings 119
Action/Description
Touch and enter the service set identifier
(SSID). Enter a maximum of 16 characters.
Select the radio band.
Select an authentication scheme.
Select a method. Then touch
characters: Network key (maximum of 64
characters), or Passphrase (maximum of 63
characters).
Select to enable radio for device communications.
When disabled, the radio is not available.
Select to activate radio network alarms when an
alarm condition occurs. When disabled, radio
network alarms are not available.
Configure radio
Touch to activate all new
radio settings not selected previously.
OK
Touch in the confirmation popup telling you to
power down the monitor.
Settings
Touch the tab. Touch the
Power down
Touch .
The radio will reboot.
Configure radio
Note If you do not touch
none of the changed radio settings will take effect.
and enter
Device
tab.
,