Welch Allyn VSM 6000 series Directions For Use Manual page 121

Directions for use
2. Touch the Parameters tab.
3. Touch the SpO2 tab.
4. Specify settings.
Setting
Default view
Default response
Sweep speed
5. Do one of the following:
•
•
Specify advanced pulse rate settings
1. Access the Advanced Settings.
a.
b.
c.
d.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the Pulse rate tab.
4. Specify settings.
Setting
Tone volume
Display source
5. Do one of the following:
•
•
Specify the manual parameters
The Manual Parameters frame is in the lower right corner of the Home tab. You can manually enter
values for parameters in the frame. You also can specify which parameters appear in the frame.
1. Access the Advanced Settings.
a.
b.
c.
d.
The General tab appears.
To continue in the Advanced Settings, touch another tab.
To exit the Advanced tabs and return to the Home tab, touch Exit.
Touch the Settings tab.
Touch the Advanced tab.
Enter the Advanced settings code.
Touch OK.
To continue in the Advanced Settings, touch another tab.
To exit the Advanced Settings and return to the Home tab, touch Exit.
Touch the Settings tab.
Touch the Advanced tab.
Enter the Advanced settings code.
Touch OK.
Advanced settings 115
Action/Description
Select a numeric view or a waveform view as the
primary SpO2 display on the Home tab.
Select the default speed of response to changes in
SpO2 measurements.
Select the waveform sweep speed for the SpO2
display in the Home tab.
Action/Description
Select a volume for pulse tones.
Select this to show the source of pulse rate
measurements (NIBP or SpO2) on the Home tab.