Welch Allyn VSM 6000 series Directions For Use Manual page 120

114 Advanced settings
5. Do one of the following:
•
•
Specify advanced temperature settings
1. Access the Advanced Settings.
a.
b.
c.
d.
The General tab will appear.
2. Touch the Parameters tab.
3. Touch the Temperature tab.
4. Specify settings.
Setting
Unit of measure
Display temperature conversion
Default SureTemp Plus site
5. Do one of the following:
•
•
Specify advanced SpO2 settings
1. Access the Advanced Settings.
a.
b.
c.
d.
The General tab appears.
To continue in the Advanced Settings, touch another tab.
To exit the Advanced Settings and return to the Home tab, touch Exit.
Touch the Settings tab.
Touch the Advanced tab.
Enter the Advanced settings code.
Touch OK.
To continue in the Advanced Settings, touch another tab.
To exit the Advanced Settings and return to the Home tab, touch Exit.
Touch the Settings tab.
Touch the Advanced tab.
Enter the Advanced settings code.
Touch OK.
Welch Allyn Vital Signs Monitor 6000 Series™
Step
If you select the algorithm, touch
enter a default cuff inflation target for each type of
patient. In the Patients tab on the Summary tab,
clinicians can change the CITs from the default
CITs that you set here.
Action/Description
Select primary units of measure for the
temperature display on the Home tab
Select this to display primary units of measure and
secondary units of measure for the temperature
display on the Home tab.
Select the default site for SureTemp
measurements. The default site applies when
clinicians power up the monitor and each time
clinicians remove the temperature probe from the
well.
Last Site
Select to set the default to the site
selected for the last measurement.
and