Planning Procedure - Siemens FS20 Planning Manual

Item no. Designation/function
1 ↑ GAP station
2 ↑ SAFEDLINK stations
3 ↑ Router stations
4
↑ Standby router
stations
5
↑ Ethernet station
(standby station or
terminal)
6 SAFEDLINK sub-net 1
7 FCnet/LAN
8 SAFEDLINK sub-net 2
9
Ethernet switch
(modular) FN2012
10 Ethernet connection
11 ● Uploading,
downloading
● SintesoView
● ↑ Management
station

8.4 Planning procedure

Building Technologies
Fire Safety
Address
Ethernet
192.168.201.1
–
–
–
–
–
192.168.100.x
–
Any
–
192.168.201.5
Table 30: Internal access to extended network via GAP
The following details must be known:
● Operating concept
● Planned system extensions
When planning the networking of the ↑ stations, proceed as follows:
1. Determine the locations of the stations.
2. Determine the location of the station with remote transmission for redundant
networking.
3. Determine the type of networking (SAFEDLINK, extended networking via
FCnet/LAN, Ethernet or mixed) and the line type.
4. Define the fire control panels that must be equipped with two network modules
(SAFEDLINK).
5. Determine the ↑ router stations for ↑ extended networking, equipped with
Ethernet switch (modular) FN2012
6. Define the station for remote access (optional).
Planning the networking of the stations
Address Notes
↑ SAFEDLINK
– Configured as GAP with DHCP
server function
– –
– –
– –
– –
192.168.1.x IP address range for SAFEDLINK
sub-net 1 (pre-setting, can be
changed)
– IP address range for Ethernet sub-
net (pre-setting, can be changed)
192.168.2.x
IP address range for SAFEDLINK
sub-net 2 (pre-setting, can be
changed)
–
Address must not be the same as
the address in the FCnet/LAN
– Connected to FN2012 of the standby
station (example)
– Ethernet client is configured to
automatically reference an IP
address (see item 1)
8
Planning procedure
107 | 242
008843_v_en_--
2015-12-15