Table of Contents
Advertisement
Type L-852A-D Dualite Bidirectional Taxiway Light Fixtures
3. Installation
Introduction
Unpacking
Input Requirement Summary
Installation Procedure
© 2001 Siemens Airfield Solutions, Incorporated
All rights reserved
WARNING: Allow only qualified personnel to perform the
following tasks. Observe and follow the safety instructions in
this document and all other related documentation.
This section provides instructions for installing the L-852A-D runway inset
lights. Refer to airport project plans and specifications for the specific
installation instructions. The installation shall conform to the applicable
sections of the National Electric Code and local codes.
Each unit is individually packaged in a durable, cushioned, corrugated
cardboard carton. To avoid unnecessary damage to the light assembly,
unpack the carton at the installation site.
To unpack the carton, open the flaps and carefully remove the top packing
material. Thread an eyebolt into each of the two opposite threaded holes.
Run a rod through the eyebolts and lift the light assembly from the
shipping carton. Set the light assembly in a protected area.
If damage to any equipment is noted, file a claim form with the carrier
immediately. The carrier may request to inspect the equipment.
The L-852A-D is designed for connection to a 6.6 A or 20 A series lighting
circuit via an L-830 isolation transformer. Refer to Table 3.
Installing the L-852A-D light fixture involves preparing the pavement
recess and wireways and installing the light fixture on an L-868B base.
Install the L-852A-D light fixture on a shallow base, if applicable.
Pavement Recess and Wireways Preparation
To prepare the pavement recess and wireways, follow the guidelines below.
•
See Figure 3. Drill the recess in the pavement. For the L-852A-D
dualite fixture, drill the hole a minimum of 4.5 in. (104.3 mm) deep.
96A0149E
Issued 5/01
Installation
Page 12
Advertisement
Table of Contents
