Siemens FS20 Planning Manual page 96
Fire detection system
Hide thumbs
Also See for FS20:
- Mounting & installation (354 pages) ,
- Commissioning, maintenance, troubleshooting (188 pages) ,
- Application manual (42 pages)
Table of Contents
Advertisement
Planning detector lines
7
Interactive Ex detector line
96 | 242
Building Technologies
Fire Safety
Supported Ex detectors
The ↑ line card (interactive, Ex) supports the same recording peripheral equipment
as the corresponding AlgoRex line plug-in module E3M171.
●
DOT multi-sensor smoke detectors: DOT1151A-Ex above SB3
●
DT heat detectors: DT1151A-Ex above SB3
●
DF flame detectors: DF1151-Ex above SB3
●
DM manual call points: DM115x-Ex above SB3
Additional documentation
●
You will find detailed information on the ↑ line card (interactive, Ex) in the
008837 product data.
●
You will find detailed information on device compatibility in the 'List of
compatibility'.
●
You will find detailed information on interactive Ex line devices in
document 1204 'Fire alarm signal in areas at risk of explosion'.
●
You will find information on key detector figures in AlgoRex document 001508
'Guidelines'.
●
You will find information on modernization and migration in documents
A6V10323158 'Modernizing fire detection installations with multiple protocol
detectors' and 009078 Configuration, chapter 'AlgoRex/SIGMASYS data
migration'.
●
You will find information about configuration and commissioning in
documents 009052 and 009078.
See chapter 'Applicable documents'.
008843_v_en_--
2015-12-15
Advertisement
Table of Contents
