Siemens FS20 Planning Manual page 92

Planning detector lines
7
AnalogPLUS detector line
92 | 242
Building Technologies
Fire Safety
External supply for line devices
The ↑ line card (AnalogPLUS) has no supply output for line devices. A separate
power supply may need to be provided.
Supported detectors
The ↑ line card (AnalogPLUS) supports the same recording peripheral equipment
as the corresponding AlgoRex line plug-in modules E3M110, E3M111, K3M111:
● Optical smoke detectors: DO113x, OP620A, OP320A
● Multi-sensor smoke detectors: DOT1131, OH620A, OH320A
● Heat detectors: DT113x, HI32xA, HI62xA
● Flame detectors: DF119x
● Manual call points: DM113x, DMA1133, MT320A
● Input modules: DC1131, EB322A
● Output modules: DC1134, DC1136, AB322A
● Input/output modules: DC1192, CB320A, ABI322A
● Collective detectors above DC1192
● Collective Ex detectors above DC1192 and SB3
● SynoLINE300C above CB320A
DC1135 is no longer supported.
Additional documentation
● You will find detailed information on the ↑ line card (AnalogPLUS) in the
008837 product data.
● You will find detailed information on device compatibility in the 'List of
compatibility'.
● You will find the information on the AnalogPLUS line devices in the
corresponding AlgoRex documents.
● You will find information about key detector figures in the AlgoRex document
Guidelines 001508.
● You will find information on modernization and migration in the documents
A6V10323158 'Modernizing fire detection installations with multiple protocol
detectors' and in the configuration 009078 in the chapter 'AlgoRex /
SIGMASYS data migration'.
● You will find information about configuration and commissioning in documents
009052 and 009078.
See chapter 'Applicable documents'.
008843_v_en_--
2015-12-15