Table of Contents
Advertisement
11.2 Mounting Procedure
Part Number
667/CI/47235/000
Table 11 : Pole Mounting Kit Document Reference
To mount the repeater the following instructions are provided;
1. Feed the clamp band through the square ball plate using the custom clamp holes
until the square ball plate is in the centre of the band.
2. Clean the area of the pole that will meet the ball plate. Remove the double stick
tape cover from the back of the plate, wrap the clamp band around the pole and
feed into the fastener. Tighten the clamp to secure it.
3. Attach the double socket arm to the ball plate.
4. Attach the repeater to the double socket arm.
5. Orientate the repeater in the direction depicted within the junction drawing and
tighten the double socket arm to secure.
Note: In cases where the repeater is to be mounted on a traffic signal pole, the
access point L-bracket (667/1/47230/000) can be used and the repeater is to be
mounted as described in section 10.1 and 10.1.1 above.
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
Document Description
Installation instructions for Pole Mounting Banding Kit
Page 66 of 117
Status
Date
Doc. No.
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Issued
March 2020
667/HB/47200/000
Advertisement
Table of Contents
