Seat Alhambra Owner's Manual page 188

the vehicle, bad weather conditions and dis-
charged batteries can considerably reduce
the range of the remote control.
An optimum range is obtained by keeping the
remote control vertical, with the aerial
›››
Fig. 201 pointing upwards. When doing
A
so, do not cover the aerial with your fingers or
with the palm of your hand.
There must be a minimum distance of 2 me-
tres between the remote control and the ve-
hicle.
CAUTION
The radio frequency remote control con-
●
tains electronic components. Therefore,
avoid getting it wet and being knocked and
protect it from direct sunlight.
Use of inappropriate batteries may dam-
●
age the remote control. For this reason, al-
ways replace the used battery with anoth-
er of the same voltage, size and specifica-
tions.
For the sake of the environment
Please dispose of old batteries so that
●
they do not harm the environment.
The remote control battery may contain
●
perchlorate. Observe the legal require-
ments for their disposal.
186
Operation
Programming the auxiliary heater
The heater or ventilation inside the vehicle
can be programmed for a certain period.
Before programming, check that the day is
correctly set in the Auxiliary heater -
›››
menu .
day of the week
Enabling the Auxiliary heater menu on
the instrument panel
From the main menu, select the Auxiliary
●
submenu and press the
heater
on the windscreen wiper lever.
OR: press the or arrow buttons on the
●
 
multifunction steering wheel until the Auxil-
menu is displayed.
iary heater
Menu op-
Description
tions
The auxiliary heater can be set to
come on automatically if required.
To do so, select a timer:
– The timer is displayed marked with
a .

– Only one timer can be selected. If
Switching
a timer has been selected, Prog.
on
will be displayed on the screen. If
Switching ON
no timer has been selected, the in-
off
strument panel display will show
.
Prog. OFF
– To change a programmed timer
you must either select a different
timer or select Disable .
Menu op-
tions
Timer 1
Timer 2
Timer 3
Duration
button
OK
Operating
mode
Day
Factory
settings
Back
Checking programming
If the timer has been switched on after
switching the ignition off, the light on the
button will remain lit for around 10 seconds.
WARNING
Never program the independent heating
system to be activated and operated in
closed, unventilated areas. The auxiliary
heater fumes contain carbon dioxide, an
Description
Three different timers (hh.mm) can
later be selected using the On op-
tion. If the auxiliary heater is to be
switched on for just a certain day of
the week, select the day of the week
and the time for the auxiliary heater
to come on.
The operating time may vary be-
tween 10 and 60 minutes and can
be set to 5-minute intervals.
Set to heat or ventilate the vehicle
interior when the auxiliary heater is
switched on.
Set the current day of the week.
The predefined factory values for
the functions of this menu are re-
stored.
This returns to the main menu.
