Seat Alhambra Owner's Manual page 91

Contents of the tyre mobility sys-
tem*
Standard display: contents of the an-
Fig. 104
ti-puncture kit.
The tyre mobility system is located under-
neath the floor covering in the boot. It in-
cludes the following components
Tyre valve remover
1
A sticker to be adhered to the instrument
2
cluster, within the driver's visual field, to
remind that the maximum advisable
speed is "max. 80 km/h" or
"max. 50 mph"
Filler tube with cap
3
Air compressor
4
1) An inflator tube may also be included.
ON/OFF switch
5
Air bleed screw
6
Tyre pressure monitoring
7
Tube for inflating tyres
8
12 volt connector
9
Bottle of sealant
10
Spare insert for valve
11
The valve insert remover
the lower end for a valve insert. The valve in-
sert can only be screwed or unscrewed in this
way. This also applies to its replacement part
.
11
WARNING
When inflating the tyre, the air compressor
and the inflator tube may become hot.
Protect hands and skin from hot parts.
●
Do not place the air compressor or infla-
●
›››
Fig. 104:
tor tube onto flammable materials while
they are hot.
Before storing the equipment, let it cool.
●
If a minimum pressure of 2.0 bar
●
(29 psi / 200 kPa) cannot be reached, the
tyre is badly damaged. In this instance, the
sealant will not be able to seal the tyre. Do
not continue driving. Seek specialist assis-
tance.
Self-help
1)
1)
has a gap at
1
CAUTION
The air compressor should be turned off af-
ter a maximum of 8 minutes since otherwise
it will overheat. Before switching it on
again, let it cool for a few minutes.
Check after 10 minutes of driving
›››
Screw the inflator tube Fig. 104
and check the tyre pressure on the gauge
Equal to or below 1.3 bar (19 psi/130 kPa):
Stop driving! The tyre could not be suffi-
●
ciently sealed with the tyre mobility system.
You should obtain professional assistance
●
›››
.
Equal to or above 1.4 bar (20 psi/140 kPa):
Correct the tyre pressure until the correct
●
›››
level is reached page 338.
Carefully head to the nearest specialised
●
workshop at a maximum speed of 80 km/h
(50 mph).
Ask the workshop to change the damaged
●
tyre.
again
8
.
7
»
89