Seat Alhambra Owner's Manual page 136

 It lights up
›››
Main beam on or flasher on
 It lights up
Headlight adjustment (Light Assist) on
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
WARNING
Observe the safety warnings
trol and warning lamps on page
Switching lights on and off
Read the additional information carefully
›››

page 26
The driver is personally responsible for the
correct use and adjustment of the lights in all
situations.
In vehicles with a trailer hook: if the trailer is
connected electrically and is fitted with a
rear fog light, the vehicle's fog light is auto-
matically switched off.
134
Audible warnings to advise the driver that
the lights have not been switched off
page 134.
If the key is not in the ignition and the driver
door is open, an audible warning signal is
heard in the following cases: this will remind
you to turn the light off.
›››
page 136.
When the parking light is on
●
When the light switch is in position
●
WARNING
The side lights or daytime driving lights are
not bright enough to illuminate the road
ahead and to ensure that other road users
are able to see you.
›››
in Con-
Always use your dipped beam head
●
109.
lights if it is raining or if visibility is poor.
WARNING
If the headlights are set too high and the
main beam is not used correctly, there is a
risk of dazzling or distracting other road
users. This could result in a serious acci-
dent.
Always make sure that the headlights are
●
correctly adjusted.
Never use the main beam or headlight
●
flasher when it can dazzle others on the
road.
Operation
›››
page 134.
.

Note
The legal requirements regarding the use
of vehicle lights in each country must be
observed.
Turn signal and main beam lever
Read the additional information carefully
›››

page 26
Convenience turn signals
For the one-touch signalling, when the igni-
tion is switched on, move the lever as far as
possible upwards or downwards and release
the lever. The turn signal will flash three times.
The control turn signals are switched on and
off from the menu Lights & Visibility on
›››
the instrument panel display
This function can be disconnected at a speci-
alised workshop for those vehicles which do
not have the menu Lights & Visibility .
Note
If the convenience turn signals are oper-
●
ating (three flashes) and the other conven-
ience turn signals are switched on, the ac-
tive part stops flashing and only flashes
once in the new part selected.
The turn signal only works when the igni-
●
tion is switched on. The hazard warning

page 28.