Seat Alhambra Owner's Manual page 100

Pull the cover forwards, in the direction of the
1.
›››
arrow Fig. 111.
Unscrew the attachment screw
2. using the screwdriver from the vehicle tool kit
›››
page 85.
Tilt the headlight slightly forward and extract it
3. from its lateral attachments
arrows).
Release the connector
4.
move it.
›››
Rotate the bulb holder
5. all the way, in the direction of the arrow, and
pull it out backwards together with the bulb.
Replace the faulty bulb with a new identical
6.
bulb.
Place the bulb holder in the headlight and ro-
7.
tate to the right all the way.
›››
Insert the connector
8. holder . The connector must audibly click in-
2
to place.
Place the headlight into its position
9.
(small arrows) and tilt it backwards.
Tighten the attachment screw
10.
using the screwdriver.
11. Replace the cover on the bumper
98
Replacing the rear lid bulbs
›››
Fig. 111
1
›››
Fig. 112 (small
›››
Fig. 112 and re-
1
Fig. 112 to the left
2
Fig. 113
Fig. 112 on the bulb
1
›››
Fig. 112
Fig. 114
›››
Fig. 111
1
er.
Complete operations only in the sequence
›››
Fig. 111.
given:
1. Open the rear lid
Emergencies
On the rear lid: remove the cover.
On the rear lid: remove the bulb hold-
›››
page 126.
Extract the cover carefully using the flat part of
2. the screwdriver from the vehicle tool kit as a lev-
››› ›››
er ( Fig. 102) on the indent Fig. 113
Release the bulb holder connector by pulling on
3.
the red connector block.
Press on the attachment tabs in the direction of
›››
4. the arrow Fig. 114 and pull out the bulb hold-
er.
Replace the faulty bulb with a new identical
5.
bulb.
Install the bulb holder. The attachment tabs
6.
should audibly click into place.
Insert the cover. The cover should lock into
7.
place.
.
1