Seat Alhambra Owner's Manual page 102

Rear light, left
Carefully insert the tail light unit into the open-
ing in the bodywork. To do this, insert the up-
13.
per rear light unit guide into the attachment
Tighten the white attachment screw using the
14.
screwdriver from the vehicle tool kit.
Ensure that the tail light unit has been correct-
15.
ly fitted and is firmly secured.
Replace the cap
›››
Fig. 115 and ro-
1
16. tate it 90° in the op-
posite direction of the
arrow.
Close the storage
17.
compartment.
18. Close the rear lid
100
Changing the number plate light
Rear light, right
ring.
Move the 12 V power
socket support up-
Fig. 117
wards gently until it is
correctly closed.
›››
page 126.
Fig. 118
holder.
Complete operations only in the sequence
given:
Emergencies
In the rear bumper: number plate light.
Number plate light: Remove the bulb
Fixed number Bolted number
plate light plate light
Press the flat part of
the screwdriver inclu-
ded in the vehicle on- Unscrew the number
board tools plate light screws us-
›››
1. ( Fig. 102) in the di- ing the screwdriver
rection of the arrow, in from the vehicle tool
›››
the groove of the kit ( Fig.
number plate light
›››
Fig. 117.
2. Detach the number plate light.
Turn the connector Separate the attach-
›››
lock Fig. 118 in the ment tabs from the
3. direction of arrow rear panel of the num-
1
and pull on the con- ber plate light by
nector. pressing.
Rotate the bulb holder
in the direction of the Take the bulb holder
›››
4. arrow Fig. 118 out of the number
2
and extract it together plate light.
with the bulb.
Replace the faulty bulb with a new identical
5.
bulb.
Insert the bulb holder
into the number plate
Insert the bulb holder
light and rotate all the
6. into the number plate
way in the opposite
light.
direction to the arrow
›››
Fig. 118 .
2
102).