Cruise Control* (Cruise Control System - Ccs) - Seat Alhambra Owner's Manual

Parking
Stop the vehicle in front of a space and se-
●
lect reverse gear.
Reverse slowly and turn the steering wheel
●
so that the yellow orientation lines guide you
›››
towards the space Fig. 255
Align the vehicle straight in the parking
●
place using the help of the green orientation
lines.
Parking parallel to the road (mode
2)
Display: orientation lines and surfa-
Fig. 256
ces for the space behind the vehicle
After applying the turn signal, the lines and
surfaces not required are deleted.
Driver assistance systems
Summary of the orientation points
Meaning of orientation lines and surfaces dis-
played on the screen
lengths of the orientation lines use a vehicle
located on a horizontal surface as reference.
.
3
Safety distance: road area located up to
1
40 cm behind the vehicle.
Vehicle side limit.
2
Turning point when parking. When the
3
yellow line touches the curb or another
limit of the parking space, the point for
changing direction (magnifying glass) will
have been reached.
Free space required to parallel park the
4
vehicle. The surface displayed must com-
pletely fit in the space.
Possible vehicle parked next to the curb.
5
Parking
Stop the vehicle 1 m away parallel to the
●
parking space and select reverse gear.
Switch on mode 2 on the navigation system
●
screen for parallel parking.
Slowly reverse and turn the steering wheel
●
so that the surface displayed yellow on the
screen stops in front of any obstacles
another vehicle).
Turn the steering wheel fully towards the
●
space and reverse slowly.
When the yellow line
●
limit of the space, e.g. the border or curb
(magnifying glass), turn the steering wheel
›››
Fig. 256. All of the
fully in the opposite direction.
Continue reversing until the vehicle is inside
●
the space, parallel to the road. Correct the
position if necessary.
Cruise control* (Cruise Con-
trol System - CCS)
Warning and control lamp

This cruise control system maintains the set speed of
the vehicle.
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
Observe the safety warnings
(e.g.
5
trol and warning lamps on page
touches the side
3
It lights up
WARNING
›››
in Con-
109.
273