Seat Alhambra Owner's Manual page 122

Close the driver's door.
●
Touch the surface sensor
●
on the door handle. The door being operated
must be closed.
In vehicles with safety system "Safe":
closing and locking the doors (Keyless-Ex-
it)
Switch the ignition off.
●
Close the driver's door.
●
Touch the surface sensor
●
on the door handle. The vehicle locks with the
›››
"Safe" security system
door being operated must be closed.
Touch the sensor surface
●
on the door handle to lock the vehicle without
the "Safe" security system
Unlocking and locking the boot hatch
When the vehicle is locked, the hatch auto-
matically unlocks on opening if
there is a valid vehicle key in the proximity.
Open or close the hatch normally
›››
page 126.
After closing, the hatch locks automatically.
In the following instances, the rear lid does
not lock automatically after closing:
If the entire vehicle is unlocked.
●
If the key used last is inside the vehicle. All
●
vehicle indicator lights flash four times. The
120
vehicle will lock again after a few seconds if
no door or boot hatch are opened.
once (arrow)
B
Locking the vehicle with a second key
If there is a vehicle key inside the vehicle and
it is locked from the outside with a second ve-
hicle key, the key inside the vehicle is blocked
for engine ignition
enable engine ignition, press the
the key inside the vehicle
once (arrow)
B
Automatically disabling sensors
If the vehicle is not locked or unlocked for a
page 238. The
long period of time, the proximity sensor on
the passenger door is automatically disa-
twice (arrow)
B
bled.
If the exterior sensor on the door handle is of-
›››
page 238.
ten activated unusually with the vehicle
locked (e.g. by the branches of a bush rub-
bing against it), all proximity sensors are disa-
bled for a time. If this only happens with the
›››
Fig. 133
exterior sensor on the driver's door, only this
sensor is disabled.
Sensors will again be enabled:
After a time.
●
OR: if the vehicle is unlocked with the but-
●
ton on the key.

OR: if the boot is opened.
●
Operation
›››
page 234. In order to
button on

›››
Fig. 131.
Keyless Access temporary disconnection
function*
You can deactivate the vehicle's Keyless Ac-
cess unlocking for a locking and unlocking
cycle.
Move the gear lever to position P (if the ve-
●
hicle has automatic gearbox), since other-
wise the vehicle cannot be locked.
Close the door.
●
Push the central locking button
●
mote control and touch the locking sensor
surface of the driver door handle
›››
Fig. 134 within the following 5 seconds.
B
Do not grasp the door handle; otherwise the
vehicle will not unlock. Deactivation is also
possible if the vehicle is locked through the
driver's door lock.
To check that the function has been deacti-
●
vated, wait at least 10 seconds, grip and pull
on the door handle. The door should not
open.
The next time the door can only be unlocked
via the remote control or the lock cylinder.
The next time the door is locked/unlocked,
Keyless Access will be active again.
Convenience functions
To close all electric windows, the sun roof
and electric tilting panoramic roof with the
convenience feature, keep your finger for a
few seconds on the lock sensor surface
on the re-

B