Seat Alhambra Owner's Manual page 97

Only replace the bulbs concerned when
●
they have cooled.
Never replace bulbs alone if you are not
●
familiar with the operations necessary. If
you are not sure about procedures then vis-
it a specialised workshop to carry out the
necessary work.
Never touch the bulb glass directly. Fin-
●
gerprints will be evaporated by the heat of
the operating bulb thus "fogging" up the
reflector.
The headlamp frameworks in the engine
●
compartment and the rear lamps contain
sharp elements. Always protect your hands
when changing bulbs.
CAUTION
After changing a bulb, if the rubber cov-
●
ers are not replaced correctly on the head-
lamp framework, the electrical installation
may be damaged, especially if water is al-
lowed to enter.
Remove the ignition key before working
●
on the electric system. Otherwise, a short
circuit could occur.
Switch off the lights and the parking light
●
before changing a bulb.
Take good care to avoid damaging any
●
components.
Fuses and bulbs
Control lamp
 It lights up
A vehicle exterior lighting bulb is not working.
Change the faulty lamp.
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
Checking the bulbs of a trailer
For vehicles with the factory fitted towing
bracket, certain trailer lights are also control-
led if the power socket is correctly connec-
ted.
A fault on a trailer turn signal is indicated on
the instrument panel by the turn signal blink-
›››
ing twice as fast ( or ) page
 
General fault of all turn signals on one side.
●
Fault in one rear light (on some models, al-
●
so the registration light).
Fault in two brake lights.
●
WARNING
›››
Observe the safety warnings
trol and warning lamps on page
Note
A fault in the LED on the rear lights will not
be indicated. However, if the fault affects
all the LEDs then this will be indicated by
the control lamp
133.
in Con-
109.
.

95