Seat Alhambra Owner's Manual page 109

Hide thumbs Also See for Alhambra:
Table of Contents

Advertisement

This option cannot be deactivated in models
destined for countries in which the second
speed must always be visible.
Start-Stop operating display.
Updated information relating to the status is
displayed on the instrument panel
›››
page
259.
WARNING
›››
Observe the safety warnings
trol and warning lamps on page
WARNING
Even though outside temperatures are
above freezing, some roads and bridges
may be icy.
At outside temperatures above +4°C
(+39°F), even when the "ice crystal sym-
bol" is not visible, there may still be patch-
es of ice on the road.
Do not rely on the outside temperature
indicator!
Note
Different versions of the instrument panel
are available and therefore the versions
and instructions on the display may vary. In
the case of displays without warning or in-
formation texts, faults are indicated exclu-
sively by the warning lamps.
General instrument panel
When several warnings are active at the
same time, the symbols are shown succes-
sively for a few seconds and will stay on
until the fault is rectified.
Compass*
in Con-
109.
Magnetic zones
Fig. 121
The compass does not require calibration in
vehicles for which the navigation system was
mounted at the factory. The option compass
disappears.
The compass in vehicles in which the naviga-
tion system was not mounted at the factory,
is permanently and automatically calibrated.
If electronic or metal accessories (mobile
phone, television) are subsequently mounted
in the vehicle, the compass should be recali-
brated manually.
Adjusting the magnetic zone
Switch the ignition on.
Select the Settings menu followed by the
option Compass and Zone .
Select the magnetic zone corresponding to
›››
the position of the vehicle
Fig.
Adjust and confirm the magnetic zone
( 1-15 ).
Calibrating compass
To calibrate the compass you must be in one
of the valid magnetic zones with sufficient
space to be able to trace a circumference
with the vehicle.
Switch the ignition on.
Select the Settings menu followed by the
option Compass and Calibrate .
Confirm the message Describe a com-
plete circumference to calibrate the
with
and then trace a complete
compass
OK
circumference driving at approximately
10 km/h (6 mph).
When the corresponding cardinal point is dis-
played, the calibration is complete.
Service interval display
The service indication is shown on the dash
›››
panel display
Fig. 120
.
4
121.
»
107

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents