Seat Alhambra Owner's Manual page 101

Replacing the rear bulbs in the
body
On the side of the boot: removing the
Fig. 115
left and right hand side rear lights.
the cap; attachment screw
2
Fuses and bulbs
Tail light on the bodywork: detach the
Fig. 116
bulb holder.
1
Complete operations only in the sequence
given.
Removing the rear light units
Complete operations only in the sequence
given:
Rear light, left
1. Open the rear lid
Open the storage
compartments on the
2. left-hand side of the
remove
1
luggage compart-
›››
ment page
Rotate the cap
3. in the direction of the
arrow and remove it.
a : lock latches.
4
Rear light, right
›››
page 126.
Move the 12 V power
socket support by
pressing gently down-
›››
wards Fig. 115
B
169. (arrow).
90°
1
Rear light, left Rear light, right
Unscrew the attachment screw
4. using the screwdriver from the vehicle tool kit
›››
page 85. The bolt is secured in its position.
Extract the rear light from the bodywork by
5.
carefully pulling backwards.
Pull the red strip on the connector and extract
6.
the connector.
Disassemble the tail light unit and place it on a
7.
flat, clean surface.
To change the bulb
To release the bulb holder, press on the attach-
›››
8. ment tabs Fig. 116 to
1 4
of the arrow.
9. Remove the bulb holder from the rear light unit.
Replace the faulty bulb with a new identical
10.
bulb.
Place the bulb holder in the tail light unit. The
11. attachment tabs should audibly click into
place.
Insert the connector and press the red attach-
12. ment strip in so that the connector is locked in-
to place.
Assembling the rear light units
Complete operations only in the sequence
given:
›››
Fig. 115
2
in the direction
»
99