Initial Registration Of E5052B; Windows 7 (Hdd Revision Nwxxx) And Windows 10 (Hdd Revision Nhxxx); Windows Vista Business (Hdd Revision: Nm321 Or Above) - Keysight E5052B Installation Manual

Installation

Initial Registration of E5052B

Initial Registration of E5052B
When you start up the E5052B at the first time, you need to perform the initial
registration for Windows operating system of E5052B.
There are three methods of initial registration procedure depending on the
windows licenses and HDD revisions of E5052B:

- Windows Vista Business (HDD Revision: NM321 or above)

- Windows Vista Business (HDD Revision: NM320 or below)
- Windows XP Pro fro Embedded Systems
- Windows 7 (HDD Revision NWxxx)
- Windows 10 (HDD Revision NHxxx)
The license is shown at the Windows License label on the rear panel of
E5052B.
It is not possible to check the HDD revision installed on your E5052B
before Windows is booted. Therefore, you should follow the procedures
below.
For Windows Vista Business and Windows XP, you cannot use the front
panel keys during the initial registration of the E5052B therefore connect
the mouse and the keyboard before turning on the power.
If you perform the following procedure incorrectly, a message asking you
whether to return to the previous registration screen and perform the
registration appears. In this case, follow the instruction to return to the
previous registration screen.

Windows 7 (HDD Revision NWxxx) and Windows 10 (HDD Revision NHxxx)

When you start up the E5052B for the first time, you need to perform the initial
registration of the Windows operating system of the E5052B.
When the Windows agreement message box appears, click Agree. The rest of
the procedure runs automatically.
Windows Vista Business (HDD Revision: NM321 or above)
Step 1. Turn on the E5052B.
Step 2. The Windows XP Professional Setup wizard appears. Click the Next > button
(Figure
26
2-7).
Keysight E5052B Signal Source Analyzer