Troubleshooting; Troubleshooting During Startup - Keysight E5052B Installation Manual

Keysight E5052B Signal Source Analyzer
Installation Guide
3

Troubleshooting

This chapter describes the troubleshooting during start up and the procedure
of the operating system (OS) recovery when the Windows OS has been
damaged.

Troubleshooting during Startup

When you encounter the problem during start up, see
recovery saves most of problems.
Table 3-1 Troubleshooting during startup
Symptom
Turning on (|) the standby switch does not
start up the system.
The system starts up, but it automatically
shuts down immediately.
The system starts up, but it enters the
service mode (The instrument status bar
in the lower right part of the screen
displays SVC in red).
The measurement screen appears after
startup, but the power on test failed,
appearing against a red background in
the instrument message/warning area in
the lower left part of the screen.
Solution
Confirm that the power cable is properly
plugged in.
Confirm that the line switch on the rear
panel is turned on
Execute the system recovery.
37
Table 3-1. System