Table of Contents
Advertisement
IMPORTANT!
Ensure your appliance is not exposed to any heat generating appliance eg cooktop,
oven or dishwasher.
The appliance has front and rear rollers for moving the appliance forward and backward.
Do not move the appliance sideways to avoid damaging the rollers or the floor
covering / s urface.
The appliance must be installed by a qualified installer, or Fisher & Paykel trained and
Check installation location
1 Check the cabinetry
– Check the dimensions — height, width, depth, floor level, finished
alcove returns.
– Ensure that the ventilation openings in the cabinetry are clear
of obstruction.
– For integrated installation, a finished return of solid material is
required across the top and sides of the new or existing alcove.
– It is recommended that the return should be at least 89mm
deep across the sides.
– Refer to 'Cavity Dimensions' prior to installation of the appliance.
2 Check the power supply
– Ensure that there is a separate power outlet for the appliance.
– Avoid sharing the power point with other appliances to prevent the
appliance from accidentally switching off.
– For power requirements, refer to the information on the serial plate.
This is located at the front right-hand side of the drawer when open.
– Ensure your appliance is properly grounded (earthed).
– Connect the appliance to the electrical supply (230VAC, 50Hz) with
fitted plug and lead.
– We recommend to use an isolating switch that is easily accessible
to the user after the appliance is installed.
– Follow the National Electrical Code and all local codes and ordinances
when installing this appliance.
3 Check the water supply
– Ensure that there is a separate water supply connection for the
appliance.
– Your appliance must be installed by a qualified appliance installer as
incorrect plumbing can lead to water leaks.
– Fisher & Paykel is not liable for damage (including water damage)
caused by faulty installation or plumbing
!2
BEFORE INSTALLATION
supported service technician to avoid faulty electrical connection and water leaks.
All connections for water, electrical power and grounding must comply with local codes
and ordinances and be made by licensed personnel when required.
Avoid installation of the appliance/s under a ground fault circuit interrupter (GFCI).
Ensure the appliance is installed properly. Improper installation that results in appliance
failure is not covered under the appliance warranty.
17
Advertisement
Table of Contents
