Change Fuse; Removing The Fuse Holder; Opening The Fuse Holder - WAGO -I/O-SYSTEM 750 User's Installation And Configuration

10 • The WAGO-I/O-SYSTEM 750
Electrical Installation
2.3.2

Change fuse

Some Power supply modules of the WAGO-I/O-SYSTEM 750 are equipped
with a fuse holder. To isolate the modules to the right of the power supply, the
fuse can be removed from the fuse holder. For this insert a screw driver into
one of the slits available on each side and lift the holder.
Fig. 2-7: Removing the fuse holder
The fuses can be removed from or inserted into the fuse holder cover. Then
push the fuse holder back into the original position.
Fig. 2-8: Opening the fuse holder
Fig. 2-9: Change fuse
p0xxx05x
p0xxx03x
p0xxx04x
Modular I/O System
ETHERNET TCP/IP